| 1. | Analysis of the effect of velocity delay compensation parameters on photo - electric servo systems
速度滞后补偿参数对光电伺服系统的影响分析 |
| 2. | 2 ) to design and realized a digital electric servo , based on scm system , integrated the can bus communication ability
2 )设计并实现了一个基于dsp的、具有can总线通信功能的电动伺服数字控制系统。 |
| 3. | In this dissertation , the main purpose is to design electric servos based on can bus by referencing existing analog electric servos and the demanding performance through studying and researching
本次论文工作的主要目的就在于通过调研，参考现有的电动伺服模拟控制系统以及系统指标要求，设计出基于canbus的电动伺服控制系统。 |
| 4. | In this dissertation , the main purpose is to design electric servos based on can bus by referencing existing analog electric servos and the demanding performance through studying and researching
本次论文工作的主要目的就在于通过调研，参考现有的电动伺服模拟控制系统以及系统指标要求，设计出基于canbus的数字电动伺服控制系统。 |
| 5. | 2 ) to design a digital electric servo , based on scm system , integrated the can bus communication ability . in this project , control function would be realized by software method other than by circuit method
2 )设计一个基于单片机系统的、具有can总线通信功能的电动伺服数字控制系统，用软件实现变结构控制方案，完全取代原有的电动伺服模拟控制系统。 |
| 6. | The author will research two different realizations : 1 ) to design a can bus interface system based on scm system . this interface system would change the digital commands obtained from the c ' an bus into the analog control signals and send these signals to the existing analog electric servos
这项工作将研究两种实现方案： 1 )设计一个基于单片机系统的canbus接口系统，用来将can总线上的数字指令转换为模拟控制信号，送给已有的电动伺服模拟控制系统。 |
| 7. | The author will research two different realizations : 1 ) to design and realized a can bus interface system based on scm system . this interface system would change the digital commands obtained from the can bus into the analog control signals and send these signals to the existing analog electric servos
这项工作将研究两种实现方案： 1 )设计一个基于dsp的can总线接口系统，用来将can总线上的数字指令转换为模拟控制信号，送给已有的电动伺服模拟控制系统。 |
| 8. | Process equipment under different choice of pneumatic or electric implementing agencies , forming an aerodynamic ball valve and electrical ball valve , such as pneumatic ball valve regulated to achieve proportional valve positioner to be allocated , such as the electric ball valve to be regulated to achieve proportional election electronic implementing agencies or distribution of electric servo amplifiers
根据工艺设备不同可选用气动或电动执行机构，分别组成气动球阀和电动球阀，其中气动球阀如要实现比例调节须配阀门定位器，电动球阀如要实现比例调节须选电子式电动执行机构或配伺服放大器等。 |
